Windows Integration Specification

form date: 2-17-2011

If you have ordered a Windows system to be integrated by DTR, please fill in the following blanks and then click the Submit button found at the buttom of this page.

Enter your name (REQUIRED)
Enter your company name (REQUIRED)
Enter your email address (optional)
Type an identifying phrase so we will know which system or site this info applies to (eg end-user company name, address, and/or server function)

It is usually possible, for a period of time, to downgrade the Windows Operating System from what you ordered. Please indicate the Operating System that we should install:

Do you want 32 or 64 bit? 64 bit is faster but some older applications will only run under a 32 bit OS. Windows 2008 non-R2 is the last server available in 32 bit. Windows 2008 R2 (and future servers) are only available in 64 bit.

Do you need the R2 version?

If disks are in a RAID array, setup this RAID level:

Note: lower end SAS/SATA raid often has no audible alarm if a drive fails.

Disk Drive 0 (or Array 0 if raid) (where the Operating System will be installed)

Name(s) of other drive letters on drive 0 (and size in GB or % allocation of remaining disk space), if any (e.g. D: 50%, E: 50%)
Note: A RAID subsystem will usually be setup as one large array 0. If so, leave the following drive questions blank.

drive 1 (or Array 1 if raid) (if present)

drive 2 (or Array 2 if raid) (if present)

drive 3 (or Array 3 if raid) (if present)

drive 4 (or Array 4 if raid) (if present)

Enter the desired Admin user name (for better security, avoid admin or administrator)

Enter the desired organization name

Time Zone
Eastern
Central
Mountain w/ daylight savings
Mountain w/o daylight savings
Pacific
Other (specify in special instructions at the end)

Licensing mode
Per Server (DTR Default)
Per Device or user i.e. Per Seat
Note: you can always change from Per Server to Per Seat later but not vice versa.

Enter the desired computer name for this system (default: win200Xsvr, e.g. win2003svr)

Administator password (at least 8 chars w/ upper, lower, digits, and punctuation)

first NIC card (ethernet) or leave the default DTR test values: 10.1.1.200 255.0.0.0
Check this to get dynamic IP info via DHCP and ignore the following 4 items:
IP address
Network mask
Default gateway or leave blank to set this later
DNS server or leave blank to set this later

second NIC card (if any) or leave the default DTR test values: 192.168.20.100 255.255.255.0
Check this to get dynamic IP info via DHCP and ignore the following 2 items:
IP address (cannot be in same subnet as first NIC)
Network mask

Will this system be the Primary Domain Controller?
yes
no

domain or workgroup name. For a Primary Domain Controller, enter a fully qualified domain name, e.g. systemname.mydomain.local

If there is a UPS, I prefer signaling via

Enter any other special instructions or requests: (Please press ENTER at the end of each line so no line is too long. You may copy/paste into this box as it will hold thousands of characters of input.

Please review all of the above information and then click the Submit button to send it to the DTR Integration group. You do not need to do anything further after you click Submit below.